Four outputs are programmable as NACs (Notification Appliance Circuits) or releasing circuits. Three programmable Form-C relays (factory programmed for Alarm, Trouble and Supervisory) and 24 VDC special application resettable and non-resettable power outputs are also included on the main circuit board. The RP-2002 supervises all wiring, AC voltage, battery charger and battery level.

Activation of a compatible smoke detector or any normally open fire alarm initiating device will activate audible and visual signaling devices, illuminate an indicator, display alarm information
on the panel’s LCD, sound the piezo sounder at the FACP, activate the FACP alarm relay and operate an optional module used to notify a remote station or initiate an auxiliary control function.

The Notifier RP-2002E conventional fire releasing agent control panel offers the same features as the RP-2002 but allows connection to 220/240 VAC. Unless otherwise specified, the information in this data sheet applies to both the 110/
120 VAC and 220/240 VAC versions of the panels.

Features Notifier RP-2002

• Listed to UL Standard 864, 9th edition.
• FM Approved.
• Designed for agent releasing standards NFPA 12, 12A, 12B, and 2001.
• Meets International Building Code (IBC) seismic requirements.
• Disable/Enable control per input zone and output zone.
• Extensive transient protection.
• Dual hazard operation.
• Adjustable pre-discharge, discharge and waterflow delay
  timers.
• Cross-zone (double-interlock) capability.
• Six programmable Style B (Class B) IDCs (Initiating Device
  Circuit).
• System Sensor i3 series detector compatible.
• Four programmable Style Y (Class B) output circuits - (special application power).
• Strobe synchronization:
  – System Sensor
  – Wheelock
• – Gentex
  – Faraday
  – Amseco
• Three programmable Form-C relays.
• 7.0 amps total 24 VDC output current.
• Resettable and non-resettable output power.
• Built-in Programmer.
• ANN-BUS connector for communication with optional devices (up to 8 total of any of the following):

– N-ANN-80 Remote LCD Annunciator
– N-ANN-I/O LED Driver
– N-ANN-S/PG Printer Module
– N-ANN-RLY Relay Module
– N-ANN-LED Annunciator Module

• 80-character LCD display (backlit).
• Real-time clock/calendar with daylight savings time control.
• History log with 256 event storage.
• Piezo sounder for alarm, trouble and supervisory.
• 24 volt operation.
• Low AC voltage sense.
• Outputs Programmable for: – Releasing Circuits or NACS
• NACs programmable for:

– Silence Inhibit
– Auto-Silence
– Strobe Synchronization
– Selective Silence (horn-strobe mute)
– Temporal or Steady Signal
– Silenceable or Non-silenceable
– Release Stage Sounder

• Automatic battery charger with charger supervision.
• Optional Dress Panel DP-51050 (red).
• Optional Trim Ring TR-CE (red) for semi-flush mounting the cabinet.
• Optional N-CAC-5X Class A Converter Module for Outputs and IDCs.
• Optional 4XTM Municipal Box Transmitter Module.
• Optional Digital Alarm Communicators (411, 411UD, 411UDAC).
• Optional ANN-SEC card for a secondary ANN-BUS.

Spesifikasi Notifier RP-2002

• RP-2002 (FLPS-7 Power Supply): 120 VAC, 60 Hz, 3.66 amps
• RP-2002E (FLPS-7 Power Supply): 240 VAC, 50 Hz, 2.085 amps
• Wire size: minimum 14 AWG (2.0 mm²) with 600 V insulation, supervised, nonpower-limited
• Door: 19.26" (48.92 cm.) high x 16.82" (42.73 cm.) wide x 0.72" (1.82 cm.) deep.
• Backbox: 19.00" (48.26 cm.) high x 16.65" (42.29 cm.) wide x 5.25" (13.34 cm.) deep.
• Trim Ring (TR- CE): 22.00" (55.88 cm.) high x 19.65" (49.91 cm.) wide.
• Shipping Dimensions:
  – Height 20.00" (50.80cm)
  – Width 22.50" (57.15cm)
  – Depth 8.50" (21.59cm)
• Temperature and Humidity Ranges: This system meets NFPA requirements for operation at 0 – 49°C/32 – 120°F and at a relative humidity 93% ± 2% RH (noncondensing) at 32°C ± 2°C (90°F ± 3°F). However, the useful life of the system's standby batteries and the electronic components may be adversely affected by extreme temperature ranges and humidity. Therefore, it is recommended that this system and its peripherals be installed in an environment with a normal room temperature of 15 – 27°C/60 – 80°F.

Agency Listings and Approvals Notifier RP-2002

The listings and approvals below apply to the basic RP-2002(E) control panels. In some cases, certain modules may not be listed by certain approval agencies, or listing may be in process. Consult factory for latest listing status.

• UL: S635
• FM approved
• CSFM: 7165-0028:0245
• MEA: 333-07-E
• Seismic Listing: Reference certificiate of compliance VMA - 45894-01 by the VMC Group

Brosur dan Datasheet Notifier RP-2002

Download Brosur Notifier RP-2002, 6 Zone Fire Alarm Control Panel disini untuk mendapatkan informasi lebih lanjut

Harga Notifier RP-2002

Kami menjual Panel Kontrol Fire Suppression System Notifier RP-2002 dengan harga distributor. Harga Notifier RP-2002, 6 Zone Fire Alarm Control Panel yang kami jual sangat murah dan bersaing dari distributor Notifier langsung di Indonesia dan terpercaya. Jika Anda sedang mencari Control Panel Fire Alarm Notifier RP-2002 bisa langsung menghubungi kami di 081317698478, 087701989383 untuk mendapatkan harga terbaik. Telepon atau WhatsApp untuk harga terbaik.

Tanya Harga Kontrol Panel Notifier RP-2002